- Thread starter
- #301
Already tried, too thick, an yes I will lean it outXacto knife but a dremel is cleaner. You'll know when your too lean because it will bog up high. Lean that thing out thats embarrassing
RcJunkie TLR 5b
- Thread starter RcJunkie13
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Cutting the shell by hand won't happen 
for now just drill more holes
for now just drill more holes
- Thread starter
- #303
Where? Just the vents?Cutting the shell by hand won't happen
You can try square drill bits junkie
- Thread starter
- #306
I doubt those vents in the front do much
Right, didn’t think of that, I actually think I have some
2 holes in the vents = a rectangle...mint 
- Thread starter
- #308
What if I disinfect the blade?
- Messages
- 13,208
- Reaction score
- 22,962
Good lord, what does how germ free the blade is have to do with cutting plastic?
Wait 
wait ...........
Ok I'm done
wait ...........Ok
I'm done
- Thread starter
- #312
at this point theres many ways to cut a hole and the best thing is a dremel and once you have one youll never be without one
- Thread starter
- #314
Ok it’s was a stupid jokeGet it... cleaner
I’m just gonna drill holes in the vents so I can play today and cut them out later
- Thread starter
- #315
this will let me play today right?, it about 90 degrees
- Thread starter
- #316
Where is the shell?
- Thread starter
- #318
Took it off, pipe melted it a little 
Post a pic
Damb that was a lot of water must have gotten soaked