Ready for a test run

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Teejay112 said:
I don't have offroad tires for bashfest that's another £101 if I do make bashfest ot will be the later one and atm my exhaust is only good for track or speed runs not oval racing the pipe is only giving me mid to top end power till I get a new one another £120 for the cheapest torque pipe I know works
Click to expand...
As said i have a set u can use while there
?
https://flic.kr/p/2c7UaTa
I'll b easy to find..:unsure:..big dude gray hair...rum n coke in hand... :p..i even got me name on me t shirt .....incase i get lost...
:ROFLMAO:
 
Teejay112 said:
Any fit the xr5 180mm outer diameter max and 135 inner diameter minimum to fit the width of the hub carrier
Click to expand...
yes I have sum grp`s...and Schumacher mini pins so every angle covered....;)
dougstar said:
Evssv has mcd tires rims ect...... think he head 2 mcd's
Click to expand...
got the rrv4...on black mcd wheels.(y)....and the losi 5b came with 2x sets.....the Schumacher and the grp`s.....plus the stock losi 5b ones...:cool:.
https://flic.kr/p/2cTLLkQ
These below needs foams
https://flic.kr/p/2bSarqb
Schu's r brand new
https://flic.kr/p/2cTLBx9
https://flic.kr/p/29cseLT
These r quite tall aswell
https://flic.kr/p/2cwwwab
 
Last edited:
Milo said:
I tend to give people the benefit of doubt. You’ve put a coupe of posts up with some dubious recommendations at best. But also I’ve not seen one picture of anything from you.

You’re also being antagonistic for no apparent reason. Anyway you’re a bell end and I’m enjoying reading your crap. Keep it up mate. ??
Click to expand...
Well said.
Side note: the word "melt" you used, definitely describes him ???
 
Teejay112 said:
why the fiddlestick would I make that up?. because you and your whole machine shop cant figure out one engine I must be a liar?I use cmr7h and with my current exhaust I get 16500 rpm no load other than drivetrain and wheels last exhaust over 17500 there are videos on YouTube and there are people who have seen my rc running it screams like a smaller bore so it looks like your machine shop could do with some help from me maybe ever thought of that rovan would benefit from me more than your team from the sounds of it and I don't have a machine shop just tools and a dremel and a floor to work on
Click to expand...

Oh snap!
 
Back
Top