SAVOX SB-2230SG Kick butt standard size servo!!!!!!!

[lorraine]

The Savox SB-2230SG is crazy strong and fast!!!
used one in new setup and gave it a quick try without end points setup and it busted up a brand new yamadude linkage kit !. Ripped the sliders off and bent both link rods! . This servo is a keeper! Lol

 

[AnubisBC]

Jayzus! That servo's a beast!

 

[lorraine]

My buddy put his junk cable front brake kit back on his from rovan and that servo will lock them up anytime anywhere and not even work it!
I thought it was a misprint as the specs put it at the same power as a 1/5 steering servo!, So I called Savox USA and they said it was not. I bought !!!!!!!!

 

[AnubisBC]

Yeah, that's a pretty insane spec for a standard sized servo. I'd be concerned about bending the carb throttle shaft on a beast like that if I didn't have the end points perfect!

But I'll bet that sucker would lock the brakes on even a stock setup!

 

[lorraine]

I got the full cnc ss carb shaft and arm kit from gizmos in my carbs so that will not happen!
Get this, Most tx/rx systems are at 250hz and if your system lets you adjust refresh rate to 333hz the holding power of these are sick. I jacked my tx up to 333hz and pushed as hard as I could and it was singing like a bird and it did not moved a bit. The servos are true 333hz and do not even get warm when driven up there in high hz, Wish I had these when we raced 1/8 scale nitro truggy........