What did the postman bring you today?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Seandonato73 said:
Post man didnt bring me anything, mother nature gave us another 6 inches of white shite
Click to expand...
Yea NO SHIZT..... I have a lot of RC stuff stuck in "your package is arriving late" status for the past 10 days. USPS tracking accuracy over the past year has been an absolute joke. Who give a terd about my packages ? it's the government, no accountability. I have a Savage ripped apart in a bazzilion pieces waiting for parts, and who knows when they will arrive.
 
Milo said:
I also got an Oddified engine which is a heavily modded g320. Knife edge crank, special heat sink, ported piston not Reed valve and run in on a dyno.
Click to expand...
That’s a pretty sweet looking little engine Milo. Did they give you a h.p. number after the dyno? Just curious.
 
Polar_Bus said:
Yea NO SHIZT..... I have a lot of RC stuff stuck in "your package is arriving late" status for the past 10 days. USPS tracking accuracy over the past year has been an absolute joke. Who give a terd about my packages ? it's the government, no accountability. I have a Savage ripped apart in a bazzilion pieces waiting for parts, and who knows when they will arrive.
Click to expand...
I'm in the same situation with my Baja, everything rear of the tank is apart! For 8 days now! Only difference is it's FedEx. Apparently they don''t know how to handle a couple days of freeze in Memphis TN. :mad:
 
How is odd to deal with? I was looking at there front diff for the fg
MonsterAir said:
I'm in the same situation with my Baja, everything rear of the tank is apart! For 8 days now! Only difference is it's FedEx. Apparently they don''t know how to handle a couple days of freeze in Memphis TN. :mad:
Click to expand...
Funny about Memphis. my parts from ddm are there too. Last shipment went south the one before it went north.wtf??
 
Bizzer said:
That’s a pretty sweet looking little engine Milo. Did they give you a h.p. number after the dyno? Just curious.
Click to expand...
Ive asked for one but the guys mum is very ill so he said he’d get it to me when he’s back at his workshop. I’ll post it once I get it.

His engine have won a lot comps over here so I’m curious to see how it compares to my Scott Finlay Promax 34 which is similar.

He told me today it’s effectively a 34 with a stuffed crank.

I’d happy with circa 9BHP.
 
Bizzer said:
Good to know. it was the 1st time I had heard of Oddified on my side of the pond, had to check them out. By the looks of the website they look pretty heavily based in racing.
Click to expand...
That’s correct but Ian Oddie will build an engine to your spec.
I told him I just want the best he has for bashing and he made me that.
 
Last edited:
not the postie, but the steel fairy dropped off some freebie steel offcuts for me today (y),
4mm plate big ovals and round slugs, and some hex 6mm hard hex bar etc,



best bits were the 6mm hex bar and a load of 10mm o/d tube thats 6mm hex drive inside ,
not sure what i'll use it for yet , but having a stock of steel is handy to have for making stuff up as and when needed (y),

 
Back
Top