Icepick is all ready to go with a stock 668 carb! New Axis stand!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Craig G.

Craig G.

Well-Known Member
Messages
107
Reaction score
136
Location
Bend, Oregon
What's up 1/5 scale insaniacs! I just wanted to show my updated work area featuring a killer Axis car stand and a full tool table! Way fun work zone! This stand arrived and I immediately cleaned my whole area and was able to put all my tools out! I'm very excited to work on my car all the time now. I went ahead and installed the original 668 carb that came on the car. I never used this and am curious now to try a choked carb just to try it out. I think I will take Icepick here to the huge Fed Ex building lot parking for a good old fashioned on road tire meltdown for the next run!
 

Attachments

  • IMG_5033.webp
    IMG_5033.webp
    80.6 KB · Views: 26
  • IMG_5034.webp
    IMG_5034.webp
    129.8 KB · Views: 28
  • IMG_5035.webp
    IMG_5035.webp
    94.2 KB · Views: 27
  • IMG_5037.webp
    IMG_5037.webp
    47.1 KB · Views: 27
Now that you have the 668 on make sure you never pull it more than twice with the choke on or you'll flood it.
After 2 pulls turn the choke off and it should start in a couple of pulls.
Great work area too!
 
Phill2 said:
Now that you have the 668 on make sure you never pull it more than twice with the choke on or you'll flood it.
After 2 pulls turn the choke off and it should start in a couple of pulls.
Great work area too!
Click to expand...
Insanely rad tip Phil! Wow. Writing it down now in the notes for sure! I better find the stock 668 settings too!
 
Back
Top