Hpi 5b rear wheels on 5t?

[DougStar]

She is ripping balls bud???

Lol no it's not THAT bad ..

Here's the outcome of paddle tires and sean im still having a bog issue...went both ways with the needle and its still draining the primer bulb.

 

[Z.hb71]

Lol no it's not THAT bad ..

Here's the outcome of paddle tires and sean im still having a bog issue...went both ways with the needle and its still draining the primer bulb.

Sounds like heat soak. What isolator are you running?

 

[Rep732]

Aluminum ddm with paper gaskets

 

[Z.hb71]

Aluminum ddm with paper gaskets

There u go, the carb is absorbing heat cuz there's nothing to isolate it from the aluminum manifold (hot). So you need a spacer like on the obr manifold (it's like30 bucks) or a teflon gasket (I recall you had sealing issues with those thought). Or just go back to plastic ?

 

[DougStar]

There's the problem ? ditch the alloy block??

Aluminum ddm with paper gaskets

 

[Rep732]

Alright ill back to the composite/plastic

 

[DougStar]

I asked Dean (bonehead rc) if he could make cf blocks? .......there's been no answer as yet but im sure he'll get back to me soon??

 

[Z.hb71]

I asked Dean (bonehead rc) if he could make cf blocks? .......there's been no answer as yet but im sure he'll get back to me soon??

I asked that a while back, he said the cf can't handle the heat and the expoxy melts

 

[Rep732]

did a little climb also...then it sunk in at the top and i had to go climb the damn hill also this is with a 21T pinion now