- Messages
- 5,832
- Location
- Maryland, USA ??
- Thread starter
- #381
Took her out today. Im still having a problem with the primer bulb staying full. I'm confused cause no matter what I do it continues to happen. It has a new top end, new tank vent, new isolator and all new gaskets, new winged clunker and new fuel lines. Same issue when i had the 990 on it. 15min good run then bulb goes empty and she starts leaning out till I shut her down. After about 20min or so primer bulb fills up again?? Could bad crankcase bearings cause this? Its the only thing I haven't replaced.