Icepick is all ready to go with a stock 668 carb! New Axis stand!

[Craig G.]

What's up 1/5 scale insaniacs! I just wanted to show my updated work area featuring a killer Axis car stand and a full tool table! Way fun work zone! This stand arrived and I immediately cleaned my whole area and was able to put all my tools out! I'm very excited to work on my car all the time now. I went ahead and installed the original 668 carb that came on the car. I never used this and am curious now to try a choked carb just to try it out. I think I will take Icepick here to the huge Fed Ex building lot parking for a good old fashioned on road tire meltdown for the next run!

 

[Phill2]

Now that you have the 668 on make sure you never pull it more than twice with the choke on or you'll flood it.
After 2 pulls turn the choke off and it should start in a couple of pulls.
Great work area too!

 

[Craig G.]

Now that you have the 668 on make sure you never pull it more than twice with the choke on or you'll flood it.
After 2 pulls turn the choke off and it should start in a couple of pulls.
Great work area too!

Insanely rad tip Phil! Wow. Writing it down now in the notes for sure! I better find the stock 668 settings too!

 

[DougStar]

I have the 668 on my fg ?? very easy to start??

 

[jimbo1]

those stands are sweet. congrats.

 

[crucialRC]

Looking good

 

[Phill2]

Insanely rad tip Phil! Wow. Writing it down now in the notes for sure! I better find the stock 668 settings too!

See settings below

 

[Craig G.]

I have the 668 on my fg ?? very easy to start??

Super rad Doug, That's what I'm looking for right now!

 

[AnubisBC]

I'm still curious to see your perception in performance between the two carbs.

 

[Phill2]

I'm still curious to see your perception in performance between the two carbs.

I've had both on my G290 and there was no discernable difference in perfomance.
The 668 is much easier to stat though.