Gforcebandit
Member
- Messages
- 6
Just bought a king motor Baja with a 30cc followed all the break in instructions got the motor going with a little trim adjustment on the transmitter idle has been raised and lowered no luck!! Any info would help.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I was thinking the same thing but I dunno where to begin, or where to find Baja specific information. Thanks!imo its gonna b ur linkage and or servo horn needs setting up right...?
You could also re adjust your linkage but it's much easier to just go back to stock setting and adust idle with the designated screw then to fek with the stupid linkage the baja usesGo back to stock trim settings, that's what is causing this. The linkage is designed for what the servo was set at previously, now youve changed its position and this is happening. Adjust idle with the idle screw on the carb,not the transmitter.
Will definitely try this out will post results tomorrow. Thank you for this useful info!You need to have your linake set at rest . Then set idle to keep it running. Where your throttle is at now is keeping your throttle "butterfly" open just a little bit to keep idle .when you come off throttle to brake its closing the throttle plate more which in turn messes with your idle which is set wrong due to the linkage hanging the throttle plate open...reset your linkage with the radio on re adjust the linkage to a completely relaxed position and put a small amount of tension on the spring
Yep@Z.hb71 do you have the specs for stock linkage travel and the exact measurements where everything should be on the throttle and brake rods?
Beat y to it ?hang on
Yeah quite handy ?Holy Jesus i can't believe hpi actually put that in the manual
Hpi ftw ??Losi doesn't give factory linkage measurements on the 5t they just tell you how they set it up to give 60% rear and 40% front braking bias Now that is a thing I miss with hpi ..details!
u sure?...Losi doesn't give factory linkage measurements on the 5t they just tell you how they set it up to give 60% rear and 40% front braking bias Now that is a thing I miss with hpi ..details!
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Large Scale RC community for RC enthusiasts that covers all aspects of the Large Scale RC!
Register Today It's free! This box will disappear once registered!
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.