Seaducer hydro build thread
- Thread starter Rep732
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 13,208
- Reaction score
- 22,962
Only watched a bit of it then skipped to the end lol.Just long enough for Sean attention span
- Messages
- 13,208
- Reaction score
- 22,962
My brother has been uploading old videos of us 4 wheeling up at Rausch creek literally me dragging an old j20 out of every possible mess they get it in with my old f 150, and I couldn't watch the 3 min video lol.Thought as much
- Thread starter
- #45
I haven't forgotten about this thread, just been busy and I hope to get this boat out before summers end.
- Thread starter
- #46
Little update: this engine has the right ingredients to run methonal so ill be trying it out shortly. Reed case, high compression, esp updated reed top end with championship porting, the engine is a 29.5
I made a methonal v stack out of delrin as I've been wanting to give it a shot. Delrin is interesting to work with and you need alot of speed on the lathe and good bits as I've learned. I've also made a delrin insulator as I felt something was missing and also felt if I put the carb right on the cade it would vapor lock, but the methonal should actually prevent it.
I made a methonal v stack out of delrin as I've been wanting to give it a shot. Delrin is interesting to work with and you need alot of speed on the lathe and good bits as I've learned. I've also made a delrin insulator as I felt something was missing and also felt if I put the carb right on the cade it would vapor lock, but the methonal should actually prevent it.
John Parks
Print my own
- Messages
- 4,151
- Reaction score
- 9,680
Very nice
- Thread starter
- #48
Thanks john...
Since the last time I've updated this I've added a gizmo hot pipe, similar to the Quickdraw hot pipe setup but no flex pipe. I've also added a prop works west race prop and just finishing setting up the radio box.
Since the last time I've updated this I've added a gizmo hot pipe, similar to the Quickdraw hot pipe setup but no flex pipe. I've also added a prop works west race prop and just finishing setting up the radio box.
Last edited: