Should be easy?? but doesn't hitec usa repair their servos if you send them in??
Crucial Kraken Vekta.5
- Thread starter crucialRC
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Thread starter
- #482
I guess but mine are savox
Ah ????
should be an easy swap ??
should be an easy swap ??
- Thread starter
- #484
Haven't made up my mind yet tho. I may just get some hitecs this time??
Are the gears the problem or the electronics inside?
- Thread starter
- #486
Gears. You can hear it trying to center itself and the gears are all loosey goosey?
Mine was hot enough to blister my finger so I think mine was the electronics but that is just a guess.
- Thread starter
- #488
Yeah I would hate to buy the replacement gearset and it still not work. The plus side is the gearset is only $30. I think I'm gonna go with the hitecs but buy 1 new gear set to see how it goes. If it goes well then I'll get the other and have some spares.
Yeah thirty bucks isn't too bad some of those gear sets are super expensive.
I got you bro! Working on it??
- Messages
- 13,208
- Reaction score
- 22,962
Thing of beauty that harness is. It's a bit of a mess, but work like none other
Why not put a servo in it's own channel ?
Takes a bit fidlesticking to get it set then y done and no ?????
Takes a bit fidlesticking to get it set then y done and no ?????
- Messages
- 13,208
- Reaction score
- 22,962
Because some of us don't want to spend hours screwing with radio settings, and your still drawing power through the rx. This method draws power straight from the battery. Cant fry an Rx this way
Cant say I had a problem ?
- Thread starter
- #496
Yeah the way the receiver melted I'm going with the bypass. Maybe the servos are pulling some crazy amps trying to move the 8" brp super spikes?? Definitely don't want that to happen again. That was a expensive lesson.
Definitely don't want that to happen again. That was a expensive lesson.
??? yes we hate loosing $$$??Yeah the way the receiver melted I'm going with the bypass. Maybe the servos are pulling some crazy amps trying to move the 8" brp super spikes??
So what's the deal with the harness ?
how dose it work?
- Thread starter
- #498
From what I see, only the signal wire goes thru the receiver. The higher current power and negative wire bypass the receiver and go straight to the servo(s) like a relay.??? yes we hate loosing $$$??
So what's the deal with the harness ?
Ok sounds straight forward ?? what receiver where you using when you got the melt?
- Thread starter
- #500
Futaba. Gotta sanwa in her now