custom part requests

[Haric]

What size is the set screw? 3mm?

 

[DougStar]

Mmmm I'm guessing. .....still in bed ??down under ???? let me finish my coffee and ill head down to the shop??
Looks to be a 4mm grub??

 

[AnubisBC]

Sorry @Haric I completely forgot that they had a set screw component to them, otherwise I would have sent one along as well!

 

[Haric]

@dougstar Almost got it? One more try and it should be good

 

[C9A5B]

What's the deal with sway bars? I don't have any on my baja, if i did run them what difference would I see?

 

[DougStar]

@dougstar Almost got it? One more try and it should be good

View attachment 62864View attachment 62865View attachment 62866View attachment 62867

YES!!!! PLEASE!!!!
all my plastic one are FEKED????????

What's the deal with sway bars? I don't have any on my baja, if i did run them what difference would I see?

Helps keep you from rolling ??

 

[siblues]

Some simpler hinge caps would be nice and when you get around to it some beadlocks would be sick too

 

[Haric]

Alright @dougstar 3rd time’s a charm ???
I’m gonna send it @AnubisBC and see if it’s a go

 

[DougStar]

Spot on @Haric ?? .....so after making them.....would it be easier the next time ? or "fek that...ill never do that again?" ????

 

[Haric]

@dougstar it’ll be easier next time for sure. I just had to get the right programming for the endmills (feeds and speed) and sequence of operation. I did break 2 endmills tho?????‍

 

[DougStar]

Question.... what size gap/slot for the bar??
Lets hope there will be some takers other than me?‍??

 

[Haric]

Question.... what size gap/slot for the bar??
Lets hope there will be some takers other than me?‍??

I’m more concerned of this hole I circled. I got the size right on the cad, but when I machined it, for some reason, was off by a little. We’ll find out in a few days when anubisbc tries it on. If it’s off I’ll make the adjustment

 

[DougStar]

Deeper or wider?

View attachment 62920View attachment 62921
I’m more concerned of this hole I circled. I got the size right on the cad, but when I machined it, for some reason, was off by a little. We’ll find out in a few days when anubisbc tries it on. If it’s off I’ll make the adjustment
View attachment 62922

 

[mark35]

Hopefully deeper, no one likes a wide hole?

 

[Haric]

Small and tight?????

 

[Seandonato73]

Hopefully deeper, no one likes a wide hole?

Zed, no ?‍

 

[Z.hb71]

Zed, no ?‍

It's like me then ??

 

[Basher5iveT420]

We need a high pressure water hose to hit Z every time he acts out. DOWN BOY DOWN!!! ??‍???

 

[Z.hb71]

We need a high pressure water hose to hit Z every time he acts out. DOWN BOY DOWN!!! ??‍???

poop. I never mind getting all wet ????????

 

[DougStar]

It's like me then ??

poop. I never mind getting all wet ????????

?‍?‍?‍?