pipeous
Well-Known Member
- Messages
- 3,269
- Location
- Surrey, BC, Canada
- Thread starter
- #81
Ok the car is ready for tomorrow. I still want to work some more on the front brakes but I have half decent brakes on the front now. I had to do a little trimming and such to get things to fit in front like the back. I put the rear body post back on but it is a bit different now. temp solution.. I tried to first drill out the hole for the body post and was going to toss a pin above and below bit there wasn't enough meat left. I was going t have to dremmel it anyway to shorten the distance to the tower. so I cut it off and ground it back about 3-4mm, drilled through the bottom body clip hole. I drilled and tapped into the metal and ran a screw through. I added some hard foam for a little extra cushioning and spacer. can't think about slamming it with this pipe on now hehe
Just waiting for shoe goo to dry as i am mounting the rubber washer to a hole getting rough from the body flopping around
Just waiting for shoe goo to dry as i am mounting the rubber washer to a hole getting rough from the body flopping around