Yeh. They seem to be out of stock of a lot of stuff too, huh? Hey, thanks again for suggesting that I just order the killswitch from killer rc. Twas cheaper even and now I don't have to wait as long to fire up my new toy, cuz ya'll got me too scared to run it without the remote killswitch.
Ya, because of the pandemic supply’s are low so when something comes in that you want have to grab it right away. Because there probably 20 other people waiting on the same thingYeh. They seem to be out of stock of a lot of stuff too, huh? Hey, thanks again for suggesting that I just order the killswitch from killer rc. Twas cheaper even and now I don't have to wait as long to fire up my new toy, cuz ya'll got me too scared to run it without the remote killswitch.
What I do is I notch the shroud and run it by the carb and below the motor, then run then connect both ends of the killswitch under the fuel tank, it's super clean and you don't see it at all. And for the radio box you can use a little epoxy or something so seal the holes
Sounds like a plan.What I do is I notch the shroud and run it by the carb and below the motor, then run then connect both ends of the killswitch under the fuel tank, it's super clean and you don't see it at all. And for the radio box you can use a little epoxy or something so seal the holes
Thanks.
That's not a baja.
I've seen it. I asked about videos specific to the baja because I want to get some ideas on wire routing and where to cut the receiver box, so yes, it does have to be a baja, but thanks anyway.
I use the hole for switch and run the cable under the battery box and tank the up to the engine. But I use a different power switch mounted to the lid.
Ok. There's an idea. Thanks. I never thought it'd be hard. I do however want to make it water-resistant into the receiver box.I use the hole for switch and run the cable under the battery box and tank the up to the engine. But I use a different power switch mounted to the lid.
Failing that make a hole where you want and run the cable through it. I can’t think of any other way or route you could take. This isn’t hard.
Glue whatever hole you use or make, job done.
No thanks.
No, I was just looking for some videos to watch in the meantime while I was waiting for my order to ship.What I was getting at is theres no specific wiring setup. Basically run your wires in a way that keeps them from heat and abrasions/cuts/water/damage.
As milo said, make adjustments as needed,such as a hole to mount the light/switch etc as needed.
Yeh, I know.
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Large Scale RC community for RC enthusiasts that covers all aspects of the Large Scale RC!
Register Today It's free! This box will disappear once registered!
