fg monster bettle pro

[blackrain]

But what if it cracks apart and get's into the engine? Just keep an eye on it.

I will , there’s none showing on the inside since crack was very small hairline crack that wrapped around. Car ran fine with it just was dripping fuel all over my chassie

 

[Troopermaniac]

I will , there’s none showing on the inside since crack was very small hairline crack that wrapped around. Car ran fine with it just was dripping fuel all over my chassie

Could have tried RTV. Would have been safer but tbh this doesn't look bad really.

 

[Seandonato73]

I would expect it to last for a little wile. We tried a ton of different epoxies for manifolds and exhaust patches. I don't think it's the temp that kills them, more so the heat cycles they go through. The smell when they start breaking down is about the worse. Keep away from it right after you start it till it's done stinking.

 

[blackrain]

I would expect it to last for a little wile. We tried a ton of different epoxies for manifolds and exhaust patches. I don't think it's the temp that kills them, more so the heat cycles they go through. The smell when they start breaking down is about the worse. Keep away from it right after you start it till it's done stinking.

Good to know didn't think about the smell. I also noticed most of them break due to vibration also more than the heat.

 

[blackrain]

Just my luck looks like the outer walls broke not sure I can put it back in and get it to stay. With no support to hold it.

 

[blackrain]

Put in a order for engine coil and pull start don't like my cars sitting needing to be fixed. Every thing should be ready to go at all times

 

[blackrain]

Put in a pipe order today went with a Vrc silenced

 

[DougStar]

For your fg? Sure it will fit?

 

[blackrain]

For your fg? Sure it will fit?

Ya, ordered this one

 

[DougStar]

Sweet take pics and report on performance

 

[blackrain]

Sweet take pics and report on performance

Will do

 

[MonsterAir]

That thing comes out the window nicely My FG pipe melts the rear of body pretty bad. I resorted to cutting the rear off so I can just slip the body's on.

 

[blackrain]

That thing comes out the window nicely My FG pipe melts the rear of body pretty bad. I resorted to cutting the rear off so I can just slip the body's on.

My stadium it should sit right inside the body like the fg pipe

 

[blackrain]

Little pipe comparison the vrc pipe has a larger chamber and stinger compared to the fg pipe

 

[DougStar]

Mount it up so we can see

 

[blackrain]

 

[DougStar]

Say goodbye to your body

 

[blackrain]

Say goodbye to your body

I know it's touching I might just trim it down some more or make new body holes and shift the body more to the right

 

[MonsterAir]

Some shoe goop and heat tape might help your cause

 

[blackrain]

First start

Was a short first start video because she cut off and had trouble getting her back started. I just replaced the coil also giving me very little spark might have set the gap to big. Should have used a thinner paper or a business card need to reset